Touchscreen thermostat | Using the function menu
The function menu allows you to enable / disable features, calibrate sensors and change modes, please see the chart below.
| Function Number | Function Description | Function Values |
| 1 | Select the operation mode of either Air and floor, Air only or floor only (Default is air and floor) | 1 = Air and Floor 2 = Air only 3 = Floor only |
| 2 | Room sensor selection, the thermostat has an inbuilt sensor but can use an external wired sensor on P2 of the wiring diagram (wired sensor not supplied) | 1 = Inbuilt Sensor 2 = Wired Sensor |
| 3 | Calibrate the room temperature, this setting is used to ensure the displayed temperature is correct. You will need a thermometer to measure accurate temperature. | Use arrow up and down to set the correct temperature. |
| 4 | Calibrate the floor temperature, this setting is used to ensure the displayed floor temperature is correct. You will need a thermometer to measure accurate temperature. | Use arrow up and down to set the correct temperature. |
| 5 | Set the floor temperature limit, this is used in air and floor mode to limit the floor temperature, the default is 28 Degrees C | Use arrow up and down to set the correct temperature. |
| 6 | Set the frost mode temperature, if set to frost mode the underfloor heating will only activate if the temperature falls below the set value, Default is 5 Degrees C | Use arrow up and down to set the correct temperature. |
| 7 | Switching differential, the switching differential is the amount of degrees between setpoint and heating reactivation. | 1 = 1 Degree (default) 2 = 2 Degree 3 = 3 Degree |
| 8 | Consumption information, 7 day log of time the underfloor is active, this is used to work out consumption. | use arrows to scroll through the days. |
| 9 | Display temperature function, Allows you to toggle between degrees C / Degrees F | Use arrow up and down to toggle between C / F |
| 10 | Number of daily set points, allows you to toggle between 2 or 4 setpoints | Use the arrows up and down to toggle between 2 and 4 default is 4 |
| 11 | Toggle the screen backlight, as default the back light is set to be on when the thermostat is being used. | 01 = Backlight enabled 00 = Backlight disabled |
| 12 | Toggle the keypad beep, this function is enabled by default | 01 = Keypad beep enabled 00 = Keypad beep disabled |